Eyeseryl All-In Peptide Solution

What Eyeseryl All-In is

Eyeseryl All-In peptide solution PFF is an eye contour active made by Lipotec. Its active is hexapeptide-2, a naturally derived peptide designed following green chemistry principles, and the PFF grade is free of PFAS. Lipotec describes it as a multifunctional peptide that acts on seven key soft tissues of the eye contour. The aim is one ingredient that addresses the look of dark circles, eye bags and wrinkles together, rather than a separate active for each concern, with visible results reported after seven days.

It sits with the ready peptide liquids in our peptide solutions section. It is a newer, broader relative of Eyeseryl Solution B, the classic Lipotec peptide for puffiness under the eyes.

Composition and label INCI

The INCI is Water (Aqua), Hexapeptide-2, Caprylyl Glycol. The active content is 0.05% hexapeptide-2, and the solution is transparent. Caprylyl glycol supports the stability of the liquid. Because the trade product is a mixture, it has no single CAS number to quote.

What it does in skin care

The eye area has thin skin and several layers that change with age: the skin surface, the fine blood vessels, the fat pads, the muscle and the connective tissue. Lipotec designed hexapeptide-2 to act across these layers, so one product can target shadows, puffiness, fine lines and a tired look at the same time. Keep claims on finished labels cosmetic, such as reducing the look of dark circles and smoothing the eye contour.

How to use it

The preferred way is to add it at the end of the process, after the emulsion has formed, at a temperature below 40 °C. It can also go into the water phase of a hot process if needed, as long as it stays at no more than 80 °C for no longer than 4 hours. The solution is water-soluble and works in a finished pH range of 3.0 to 7.0.

Pairing ideas

Eyeseryl All-In fits eye creams, eye gels, roll-on serums and eye patches. It layers well with caffeine, hyaluronic acid and other eye peptides. In a firming eye cream, combine it with a smoothing peptide such as Argireline, and keep the base light and fragrance free for the eye area.

Trademark note

Eyeseryl is a registered trademark of Lipotec. The INCI can be used freely on an ingredient list, but using the trade name in your own marketing requires a trademark agreement with Lipotec. Check this before naming it on a front label.

Bench example: all-in eye gel

This 30 g bench batch shows one way to use the material. Weigh 26.37 g distilled water, 1.2 g glycerin and 0.03 g sodium hyaluronate, and let the hyaluronate hydrate fully. Add 0.3 g hydroxyethylcellulose and stir until it forms a light gel. Add 0.6 g Eyeseryl All-In, 0.9 g propanediol, 0.3 g panthenol and 0.3 g broad-spectrum preservative used at its supplier rate. Check that the pH sits between 5.5 and 6.5, and fill into a roll-on or airless pump.

Where it fits in a product line

Eyeseryl All-In suits brands that want a single, well documented peptide at the heart of an eye range. It works in a light morning gel for a fresh look, in a richer night eye cream, and in hydrogel patches. For eye products, test the finished base for comfort around the eyes and use fragrance-free, low-irritation ingredients throughout.

Storage

Keep the container tightly closed in a cool place away from light and heat. Close the pack quickly after each use. For cosmetic formulation use only.